Protection Circuit Module (PCM) for 4 cells (12.8V) LiFePO4 Battery Pack at 16A limited (#5175)

This protection circuit is specially designed for 12.8V LiFePO4 Battery pack with 16A discharging rate. Different than normal PCB, it provides equilibrium function after battery pack is fully charged. PCM will detect each cell's voltage and trim higher voltage down until other cells reach the same voltage level. Therefore, it helps LiFePO4 cells have longer service life.

Protection Circuit Module Specifications  For 12.8V LiFePO4 Battery  Pack
Model：PCM-LFP12.8V16A
Over-charge protection voltage	3.90 V±25 mV
Over-discharge protection voltage	2.3±0.08V
Over-current protection	90-110A
Maximal continuous Discharging current	16A
Maximal Current consumption	≤20uA
Short circuit protection	Automatic Recovery
Protection  circuitry  resistance (B- TO P-)	≤50mΩ
Dimension	127mm(5.0") x 48mm(1.9") x 8mm(0.3")
Weight	50 grams
P+/P-	P+ = Charge+ / Discharge + P- = Charge- / Discharge -
Specification	Download Specification

For other PCM/PCB, please check our PCM/PCB/BMS/CMB/UPS category

Warning

• If you want to use this protection circuit board for a battery that is less than the rated drain, you must add additional protection device to protect the battery itself. Such as: proper rated polyswitch. 
• To achieve balance, each cell in battery pack must has equal voltage within tolerance. When charger LED turn Green, allow 30 minutes for pack to balance before use.
• You must be professional in Lithium battery pack to buy the protection circuit board. Misusing may cause battery damage or explode. We are not responsible for any damage caused by user.