Protection Circuit Module (PCM) with Equilibrium Function for 5 cells (16.0V) LiFePO4 Battery Pack at 10A limited (#4880)

This protection circuit is specially designed for 16V LiFePO4 Battery pack with 10A discharging rate. Different than normal PCB, it provides equilibrium function after battery pack is fully charged. PCM will detect each cell's voltage and trim higher voltage down until other cells reach the same voltage level. Therefore, it helps LiFePO4 cells have longer service life.

Protection Circuit Module Specifications  For 16V LiFePO4 Battery  Pack
Model：PCB-LFP16V10A
Over-charge protection voltage/Single Cell	3.90 V±25 mV
Over-discharge protection voltage/Single Cell	2.0±0.05V
Over-current protection	45±10A
Maximal continuous Discharging current	10A
Maximal Current consumption/Single Cell	≤20uA
Protection  circuitry  resistance (B- TO P-)	≤50mΩ
Dimension	66mm(2.6") x 44mm(1.8") x 12mm(0.6")
Weight	1.0 Oz (28.3 grams)
P+/P-	P+ = Charge+ / Discharge + P- = Charge- / Discharge -
Specification	Download Specification

For other PCM/PCB, please check our PCM/PCB/BMS/CMB/UPS category

Warning

• If you want to use this protection circuit board for a battery that is less than the rated drain, you must add additional protection device to protect the battery itself. Such as: proper rated polyswitch. 
• To achieve balance, each cell in battery pack must has equal voltage within tolerance. When charger LED turn Green, allow 30 minutes for pack to balance before use.
• You must be professional in Lithium battery pack to buy the protection circuit board. Misusing may cause battery damage or explode. We are not responsible for any damage caused by user.