|
|
|
|
|
|
Fuel Gauge for 30S (36V) NiMH/Nicd Protection Circuit Board (#6140)
|
In Stock
Product ID # 6140 Part Number: FG-MH30S
|
Note: This fuel gauge is not intended to be used as a very accurate reading of the battery pack's capacity. The battery level indication can vary by 5% depending on the capacity of the pack!
Features
- Apply to PCB/PCM of 30 cells Nimh/Nicd 36V battery pack.
- No external power is needed
- Can connect directly to pcb/pcm via special connector on board or connect directly to output of battery pack
- 5 LEDs display battery pack's voltage. The voltage listed below is based on battery during discharge. (The actual voltage might vary for LED 2-4 during charging.)
- The following data is tested under 25ºC
- No LED on = Pack Voltage≤30V±1V, must recharge battery
- 1 LED Red = pack voltage: 30V±1V to 33V±1V (battery need recharging)
- 1 LED Red, 1 LED Green = pack voltage: 33V±1V to 36V±1V
- 1 LED Red, 2 LED Green = pack voltage: 36V±1V to 39V±1V
- 1 LED Red, 2 LED Green = pack voltage: 39V±1V to 42V±1V
- 1 LED Red, 4 LED Green = pack voltage: 42V±1V ( battery is fully charge)
Specifications
- Power consumption: Max 2mA (no LED on)
- Dimension (LxWxH): 51mm x 26mm x 4mm
- Weight: 5g
- Connector: 5.3" long 2 pin Female SH connector
Warning:
- Please check polarity before making connection to avoid damaging the module.
- This fuel gauge is use for 36V pack only or it will damage the fuel gauge.
- Please make sure your selection is correct before purchasing.
How to connect to the excluded PCB
|
The LED fuel gauge locate on the pack's surface by double side tape
|
|
Product Reviews
|
|
|