Custom Polymer Li-Ion Battery: 3.7V 10Ah (37Wh, 5A rate) with JST-XHP-3 Connector

• 3.7V 10Ah Li-Ion Battery pack is made of 2 pcs of 3.7V 5000 mAh (PL896474) with Built in Protection IC (PCB) & Polyswitch to avoid battery over charge and over discharge.
• 1x 5.5A Amp polyswitch
• 1x 10K NTC
• 1x  PCB (5A) installed with the  battery pack and protects the battery from
  • Overcharge       (>4.2V)
  • Overdischarge  ( <2.5 V)
  • Over drain ( >6.0 Amp)
  • Short circuits

• 9" long 22AWG with JST-XHP-3 Connector
• Pin 1 = +, Pin   2 = -, Pin 3 = NTC white wire
• 

78mm (3")x 64mm (2.5") x 20mm (0.75")    

• You can use our Smart Fast Charger (3.0A) for 3.7 V Li-ion Rechargeable Battery Pack to recharge the battery pack, charge time is about 5 hours.   
• Other battery module made by 3.7V 5000mah cell can be found here 
• Connector & Wire section
• Fire Retardant Bag: 295mmx230mmx75mm --- Reduce the chance of damage if caught fire
  • This Fire Retardant Bag (Li-Ion Safer Bag) is intended to reduce the chance of damage in the event of catching fire.
  • Must locate & seal the battery pack in the bag  while charging / leaving without any attention 

• Li-Ion battery may explode if misused.  We are not responsible for any damages or losses caused by misuse.
• Always charge battery with attention. Battery pack should be placed in a fireproof place to avoid any accidents.
• Please don't use the battery modules to make series connection or parallel connection with more than 2 packs, otherwise battery service life may be reduced.
• For safety warning please see the link here
• California residents: Warning: Cancer and Reproductive Harm - See Prop 65 Warnings
•