|
|
|
|
|
|
PCM with Equilibrium function for 18.5-29.6V Li-Ion / 16V -25.6V LFP Battery Pack @ 10A limit -- 5 Pcs Min Order (#6226)
|
Call for Order & Lead Time
Product ID # 6226 Part Number: PCM-SM16
Personalizations
* denotes required field
Battery Pack Voltage*
|
This protection circuit is specially designed for 18.5V - 29.6V Li-Ion / 16V-25.6V LiFePO4 Battery pack with 10A discharging rate. Different than normal PCB, it provides equilibrium function after battery pack is fully charged. PCM will detect each cell's voltage and trim higher voltage down until other cells reach the same voltage level. Therefore, it helps Li-Ion cells have longer service life.
|
Test item
|
Criterion
|
1 |
Voltage |
Charging voltage |
CC/CV:Li-ion/Li-polymer(4.2V/cell),LiFePO4(3.6V/cell)
|
Balance voltage for single cell |
Li-ion:4.20 V±0.025V,LiFePO4:3.60V±0.025V |
2 |
Current |
Balance current for single cell |
0~85mA |
Current consumption for single cell |
≤20μA |
Maximal continuous charging and discharging current |
10A |
3 |
Over-charge Protection |
Over charge detection voltage |
3.8~4.4V(can adjust) |
Over charge detection delay time |
0.5~2.5S |
Over charge release voltage |
3.8~4.4V(can adjust) |
4 |
Over-discharge Protection |
Over discharge detection voltage |
1.9~3.1V(can adjust) |
Over discharge detection delay time |
50~300mS |
Over discharge release voltage |
1.9~3.1V(can adjust) |
5 |
Over-Current Protection |
Over current detection voltage |
0.6V |
Over current detection current |
50±10A |
Detection delay time |
1~50ms |
Release condition |
Cut load |
6 |
Short Protection |
Detection condition |
Exterior short circuit |
Detection delay time |
200-500us |
Release condition |
Cut load |
7 |
Resistance |
Protection circuitry(B- to P-) |
≤60mΩ |
8 |
Temperature |
Operating temperature range |
-40~+85℃ |
Storage temperature range |
-40~+125℃ |
9 |
Size |
|
60mm(2.4") x 39mm(1.5") x 12mm(0.5") |
10 |
Specification |
For 22.2V Li-Ion Battery For 29.6V Li-Ion Battery For 25.6V LiFePO4 Battery |
|
For other PCM/PCB, please check our PCM/PCB/BMS/CMB/UPS category Warning
- If you want to use this protection circuit board for a battery that is less than the rated drain, you must add additional protection device to protect the battery itself. Such as: proper rated polyswitch.
- To achieve balance, each cell in battery pack must has equal voltage within tolerance. When charger LED turn Green, allow 30 minutes for pack to balance before use.
- You must be professional in Lithium battery pack to buy the protection circuit board. Misusing may cause battery damage or explode. We are not responsible for any damage caused by user.
|
Product Reviews
|
|
|