About Payment 
 Shipping & Cost
 Battery SDS
 Battery Terminology
 Battery Knowledge
Privacy Policy
 Export restrictions


Shopper Award
Security Verified Seal

Smart Gang Charger: 3 Channels 9.6V-18V (0.9A-1.8A) NiMH/Nicd Battery Charger

Your Price: $69.95
In Stock

Product ID # 3866
Part Number:

Quantity Discounts

5 to 20$67.85
21 to 50$66.45
51 to 100$65.05
101 or more$62.96



  • Good for rapid charging 36V NiMH/NiCd battery pack which consist of 3 x 12V NiMH/NiCd battery modules in serial connection to achieve better power balance.
  • Good for Hobby shop or Lab to charge three NiMH battery pack (9.6V - 18.0v) at the same time at faster speed and lower cost.
  • 120-240Vac input for worldwide use.
  • The smart charger can automatically detect battery pack's voltage, Red LED will be on during charging. Green LED when pack is fully charged
  • Automatically cut-off by negative delta V when battery pack get fully charged.
  • Two current levels selectable,  e.g.  0.9A and 1.8A  by a switch in the front panel.
    • For battery pack between 1100mah and 2100mah, please use the low level switch -- charging rate: 0.9A
    • For battery pack over 2100 mAh, please use the high level switch -- charging rate: 1.8A

Please download the Specification here

Operation Instruction

  • Connect AC power first, then connec battery pack(s) to output connector(s)
  • Make sure battery polarity is connected correctly (Red wire is positive)
  • When the unit connect the AC source, the red LED and green LED flash for two times, then all off.
  • After it connect the correct battery pack, the red LED will be on, shows that it is charging.
  • After battery is fully charged, green LED will be on and it shows the battery fully charged.


  • Please don't use the charger for low capacity battery pack (<900mah) strongly suggestion to use Powerizer brand high drain rate battery pack. We are not responsible for any damage caused by charging other brand battery using this charger.
  • Please don't use the charger to charge 6V battery pack .
  • Brand New design with Pending Patent.
  • Please plug in AC power first, then connect the battery to the charger, otherwise, there is no output from the charger.
  • Must leave plenty of space around the charger to have air flow to keep the charger cool during operation. Otherwise, the charger generate too much heat which will damage the charger and the battery being charged

Related Products

Product Reviews

(0 Ratings, 0 Reviews)

Thermal Spread Material used in Battery Pack Assembly
UN 38.3 Safety Test

We own a national standard UN38.3 testing lab. We can provide UN38.3 test service to our customer.

If you want to set up your own lab, we also provide UN38.3 & IEC62133 equipments and onsite training. Email us for the quote and lead time.
Thermal Abuse Test for IEC62133
Lithium Battery Shipping Regulation
Show & Conference
Lithium Battery Power and Safety, Baltimore MD, Nov 17-19, 2015
The Battery Show, Novi. MI, Sept 15-17, 2015 Booth#1716
Battery Power 2015, Denver, CO, August 5-6, 2015 Booth#29
Next Generation Batteries Conference, San Diego, CA, April 21-22, Booth#9
32nd International Battery Exhibit, Mar.9-12,2015, Florida, Booth #209
More ...
Mailing Lists