Compact Smart Charger (0.6 A ) for AirSoft Gun Battery Packs 7.2V - 12 V -- UL / CE listed

• Manufacture part# H01200006-US-1
• It is Universal  Smart Charger for any NiMH /NiCd battery packs from 7.2V-12V 
• 90-260V AC input for world wide voltage support.
• Compact size, directly plug in without power cord, and easy to carry.
• Charging current is 600 mA
• Designed for slow charging  7.2V-12V  NiMH and NiCd Battery Packs. Built in IC will recognize battery pack voltage ( from 7.2V- 12V ) automatically without setting.
• Idea for RC air battery pack and battery pack with capacity < 4000 mAh
• Using Pulse and Negative pulse technology ( 10% negative plus ) to avoid battery overheating and polarized during fast charging, Significantly increasing battery pack's cycle life.
• Automatically detect battery pack's voltage, Red LED will be on during charging.
• Automatically cut-off by negative delta V when battery pack get fully charged.
• Protection fuse for over current, short circuit & reverse polarity protection.
• Charging time from approx. 30 mins to 100 mins depending on the capacity of battery.
  • For 3000 mAh battery pack, charging time is about 5 hours
  • for 2000 mAh battery pack , charging time is 3.5hours.
  • For 600mAh battery pack , charging timer is about 1.2 hrs
• One standard Tamiya female connector installed with the charger. Ideal for charging all 7.2V, 8.4V,9.6V and 12V RC Car, RC air and Airsoft battery packs .
• Charging terminal: 3' 7" long 22AWG Standard Female Tamiya plug  
  •  Included one connector adapter from standard Male Tamiya to Female Mini Tamiyafor charging Airsoft  battery packs. (Please click picture to enlarge)
  •  Included one pcs connector adaptor, convert from Standard Male Tamiya plug to alligator Clip for charging any battery packs.  (Please click picture to enlarge) 
• It is very smart charger. You don't need take care anything, just plug in and wait for battery charging ready
• Size (LxWxH): 3.4" x 2.1" x 2.1" include plug (without plug 1.2") 
• Weight: 4.8oz.(140 grams)
• UL / CE listed
•    Please click here to download the instruction manual

Operation Instruction:

• Connect battery pack to output connector and plug AC power source
• Make sure battery polarity is connected correctly (Red wire is positive)
• When the unit connect the AC source, the red LED and green LED flash for two times, then all off.
• After it connect the correct battery pack, the red LED will be on, shows that it is charging.
• After battery is fully charged, green LED will be on and it shows the battery fully charged.

Precautions:

Please don't use the charger for low capacity battery pack (<600mah).. strongly suggestion to use Powerizer brand high drain rate battery pack. We are not responsible for any damage caused by charging other brand battery using this charger.

Smart Tip:

Via a battery holder( 6- 10 cells) , you can use this smart charger to recharge a group single cell  ( 76- 10 pcs ). When you do so, you must set charging current at lowest level

Back View with CE listed