Features

• Universal Smart Charger is designed for any NiMH/NiCd battery pack from 2.4V- 7.2V with capacity > 600mAh
• 100-240V AC input for world wide power support.
• Ideal for 4.8V - 7.2V NiMH battery packs of RC flight, RC car, Bikelighting and rechargeable flashlight.
• It can alse be use as a battery charger module for any DC device
• It is a very smart charger. Just plug it in and wait for battery to charge
  • Automatically detect battery pack's voltage, Red LED will be on during charging.
  • Automatically cut-off by negative delta V when battery pack is fully charge.
• When battery is fully charge, LED will change from Red to Orange color.
• Two current levels 0.6A and 1.2A, are selectable by a switch
  • For battery pack less than or equal to 1200mAh, please switch charging rate to 0.6A
  • For battery pack over 1200 mah, please switch charging rate to 1.2 A
• The fuse is installed in power line for protection of over current, short circuit & reverse polarity protection. It is easy to replace. Two extra fuse is included .
• Charging time is about 4 hrs for 4500 mAh battery pack, 1.5 hrs for 1800 mAh, and 1hr for 1200 mAh.
• One standard Tamiya male connector is installed with the charger.
• One set of Clip adapter with a female tamiya connector included for charging any battery packs.
• One connector adaptor from standard Female Tamiya to Male Mini. Tamiya for charging RC air battery packs.
• Dimension: 1.5"H X 2.5"W X 5.5"L.
• Weight: 0.6LB.

Fuse Replacement: ---- The fuse in cable will broken if make wrong polarity connection between charger and battery.

Below is a demonstration how to replace the broken fuse. The fuse is 2A rate, which is available in home deport or any electronic store

Precautions:

• The charger is designed for fast charging NiCD and NiMH battery packs from 2.4V to 7.2V battery. with capacity > 600 mAh.
• Please don't use the charger for low capacity battery pack (600mah).
• Please don't charge battery pack with voltage < 2.4V or voltage > 7.2V
• Please make sure polarities between charger and battery pack are match before charging the battery. Otherwise wrong polarity may burn the fuse and damage the charger.
• The charger is designed for indoor use only.
• The charger should be horizontally position and work in well ventilated condition. Avoid it being wet and keep it away from flammable/ explosive goods.
• Cut off the power supply before connecting or disconnecting the charger with batteries.
• Strongly suggest to use Powerizer brand high drain rate battery pack. We are not responsible for any damage cause by charging other brand battery using this charger.

Smart Tip:

• You can choose our 110W DC-AC inverter, then you can use charger in your car
• You can combine this charger with various size battery holders to charge all sziess of single cells (2-6 cell) ( must choose small charging current if use holder)
• If you would like to use this charger to plug with various connector instaed of Tamiya, please choose one of your connector in our connector section