Packing	14.8 V 20Ah pack is made by 8 pcs High Power Polymer Li-Ion Cell: 3.7V 10 Ah in 4S2P configuration Battery pack is placed in Plastic Enclosure(Box-10-22) Two heavy duty binding post are installed on outside box (Red positive ) Fuel Gauge for PCB of 14.8v Li-Ion Battery Pack (4 cells pack) is installed on surface of battery pack Touch the switch on the display , you can monitor the energy level of battery pack
Voltage	14.8 v (working) 16.8 V ( peak)
Capacity	20 Ah (296 wh)
Cycle life	>300
Prewired	One PCM with balance function is installed with the battery pack to protect battery from Overcharging beyond 4.25V/cell Over-discharging below 2.75V/cell Over-drain beyond 30 A Must wait min of 30 minutes after battery is fully charged to allow the pcm to perform balance function on all the cells within the pack. Charge/Discharge terminal: Copper Barrel Lug terminal attached via Binding Post Barrel Lug terminal size: 0.6"(14mm) L x 0.3" (8mm) W x 0.04" (1mm) H Binding Post size: 0.8"(19mm) Dia x 1.2"(30 mm) L Red Binding Post = Positive Black Binding Post = Negative Must use proper AWG wire gauge to match up the max discharge current (30A), Please click here for American Wire Gauge table and AWG Electrical Current Load Limits table. You may consider to DIY with our wire below. 14AWG Red wire and 14AWG Black wire. 16AWG Red wire and 16AWG Black wire.
Max. Discharging Rate	30 Amp limited by PCM
Dimensions (LxWxH)	232mm (9.2") x 120mm (4.8") x 3.0"(75 mm) L is the length with Binding Post's length
Weight	4.7Lb (2134 grams)
Smart Tips	For fast charging (5.0 hrs) , You may use 6.0A Smart Li-ion battery charger + Connector Adaptor: From 4 Pin male Cannon plug to Clips You shall choose our 3.0A 14.8V Smart Li-Ion battery charger to recharge this battery pack via clip connector included. The estimated charging time is about 10 hours. If you connect two of these modules in parallel, you may build a 14.8 V 40 Ah Battery pack Must plug Standard Male Tamiya end to the Standard Female Tamiya plug of the charger with correct polarity. Must plug Clip end to the connector of the battery pack with correct polarity Red Clip = Positive Black Clip = Negative Warning: Wrong polarity will damage the charger, Batteryspace are not responsible for the damage or losses caused by misusing Need High Power Polymer Li-Ion Module: 14.8v 50 Ah (740 Wh, 60A rate) with PCM? Please click here to order
Applications	Replace 12V NiMH battery pack for emergency backup power bank Please click here to see the Comparison Poly-Li pack vs NiMH / SLA to know more the advantages
Warning	Please note this battery is for R&D use only and NOT for individual customers. We are not responsible for any damages or losses caused by misusing Please never discharge the battery pack beyond its Max. rating Must read before place an order. Please download fill the form and fax back to 510-439-2808. Attn: BatteySpace-Tech. For safety warning please see the link here
Warranty	Limited Warranty: Repair or exchange only within 30 days.