About Payment 
 Shipping & Cost
 Battery SDS
 Battery Terminology
 Battery Knowledge
Privacy Policy
 Export restrictions


Shopper Award
Security Verified Seal

Category : Airsoft Gun Batteries

How to choose airsoft gun battery?
  • It is difficult for us to tell you which battery is for which airsoft due to so many models on the market. However, It is easy for you to decide using the follows:

    • Measure the battery compartment size in your gun with a ruler, then choose a battery pack between 8.4V - 9.6V that has a smaller size than battery compartment. Most NiMH battery pack between 8.4V and 9.6V will work for airsoft. 9.6V will provide faster shooting, but less firing time. 8.4V will provide longer firing time, but a little slower shoot. If battery compartment space allowed, choose a higher mAh (capacity) battery. Higher mAh ( at same voltage) will provide longer shooting, but more expensive. Always keep the connector from your old battery. In case, connector of new pack does not match, you can replace it with old one.

    • NiMH or NiCd battery pack? Please select NiMH battery pack as it is much better than old NiCd

  • Warning: Mini Airsoft battery  with mini tamiya connector  has opposite polarity that is similar to RC car battery. When you order airsoft battery, please

    • Always order charger in our related products area, don't use the charger for RC car battery for airsoft

    • Please always double check battery polarity before charging battery, make sure Red wire on charger must match the red wire of battery

    • For safety reason you should use one charger per pack. Please do not use one charger to charge more than one pack either in series or in parallel setup. We are NOT liable for any damage due to this configuration.


8.4 V Airsoft Battery Packs Series
Mini 1100 mAh, standard 3300 mAh, ...
9.6 V Airsoft Battery Pack Series
Mini 1100 mAh, standard 4200 mAh, ...
10.8 VAirSoft Battery Pack Series
2/3 A 1100mAh, SC 4200mAh etc.
12 V Airsoft Battery Pack Series
Mini 1100 mAh, standard 4200 mAh, ...
Single Cell with Tab for DIY Power Packs
NiMH 2/3A, A, SC 3300 - 4500 mAh & Hi-powe Polymer

Thermal Spread Material used in Battery Pack Assembly
UN 38.3 Safety Test

We own a national standard UN38.3 testing lab. We can provide UN38.3 test service to our customer.

If you want to set up your own lab, we also provide UN38.3 & IEC62133 equipments and onsite training. Email us for the quote and lead time.
Thermal Abuse Test for IEC62133
Lithium Battery Shipping Regulation
Show & Conference
Lithium Battery Power and Safety, Baltimore MD, Nov 17-19, 2015
The Battery Show, Novi. MI, Sept 15-17, 2015 Booth#1716
Battery Power 2015, Denver, CO, August 5-6, 2015 Booth#29
Next Generation Batteries Conference, San Diego, CA, April 21-22, Booth#9
32nd International Battery Exhibit, Mar.9-12,2015, Florida, Booth #209
More ...
Mailing Lists