Smart Charger (40A Max) for 3.2V LiFePO4 Battery Pack (110Vac only, 1.9" x 1.5" x 0.6" Standard Anderson plug) --- CE listed

• Intelligent charger designed for any 3.2V (1 cell) LiFePO4 Battery pack including Polymer LiFePO4 and Cylindrical LiFePO4 with capacity >= 40Ah
• Manufacture part# KP0440FL
  
• 90-120V AC input for USA Only. 50-60Hz, Detachable AC power cord,

• Built in cooling fan to ensure charger long service life

• CCCV (Constant Current Constant Voltage) charging mode at 6A
  

• Charge terminal: 1' long 8AWG wire with a 1.9" x 1.5" x 0.6" Standard Andersen connector 

  • Anderson connector dimension (LxWxH):1.9"(48.0mm) x 1.5"(38.0mm)  x 0.6" (15.0mm) 

  • Included 1 pcs 1.9" x 1.5" x 0.6" Standard Anderson connector without wire for DIY use.

    • Tip: In order to match up the charger's connector,You may connect the battery pack charge terminal with Included 1 pcs 1.9" x 1.5" x 0.6" Standard Andersen connector. 

    •  Make sure the charge DIY wire will be acceptable for 40A Max charge current. Please click here to see American Wire Gauge table and AWG Electrical Current Load Limits

    • Warning:  Wrong polarity will damage the charger, and Batteryspace are not responsible for the damage or losses caused by misusing

  • Note:  Anderson connector is a non-gender connector. Check for correct polarity before connect your charger to your battery pack.
    

• Charging Current
  • 40A Max charging rate
• Output: 3.65VDC
• Charging time:
• Charging time = (1.41 x Ah rate of the pack) / 6.0A charge current.

• Safety Protection:

  • Over voltage protection
  • Short circuit protection
  • Output reverse input protection
• The charger will cut off automatically if battery is fully charge
  • Cut-Off voltage = 3.65 +/- 0.05V
•  LED indicate for charging status
  • Power LED Indicator: Red = Power On 
    
  • Charge LED Indicator: Red = Charging, Green = Fully charged
    
• Note: You must connect charger to AC power before connect to battery pack. Otherwise, the charger will NOT charge the pack and you will not get a RED LED indicate charging.
• Dimension (LxWxH): 265mm(10.4")x138mm(5.4")x74mm(2.9")
• Weight: 6.0lbs 3.8Oz (2830g)  
•  Please click here to download the instruction manual  
  
• Note: Must disconnect the AC power if disconnect battery for  > 3min to reset the charger 

Warning:

• Only charge LiFePO4 battery pack with capacity > 40Ah. Don't use the charger for lower capacity LiFePO4 battery pack.
• Only charge LiFePO4 battery pack with voltage 3.2V (1 cell pack). Don't use the charger for Lower voltage battery pack which may cause battery to explode
• We are not responsible for any damage caused by misuse.
• Indoor use only
• Don't remove the case to prevent from electric shock
• Unplug the charge from AC outlet after use.