|
Compact Digital Battery Monitor for Any 0-60V Rechargeable Battery Pack (14AWG Anderson plug, For Monitor Charging Only)
|
|
In Stock
Product ID # 6364
Part Number: TS-WUD
|
FEATURES
- Measures electronic Parameter below while charging only
- Voltage (V)
- Current (A)
- Amperage charging current will have a +/- 0.2A tolerance based on battery pack's internal impedance.
- Power (W)
- Electronic Charge (mAh)
- Electronic charge is a physical property of matter, which causes to experience a force when near other electrically charged matter
- Temperature ('C)
- Perfect use with Smart Charger (10 A, Watt-Meter Buit In, Large Alligator Clip plug) for 12.8V LiFePO4 Battery Pack Worldwide use to monitor a LiFePO4 Prismatic Battery: 12.8V 40Ah (512Wh, 30A) with PCM & Watt Meter
- To prevent high self - discharge rate phenomenal from battery analyzer, Must disconnect the battery analyzer from both charger and battery pack after use.
- Connection diagram: Smart Charger --> Source terminal --> Load terminal --> Battery pack
- Source / Load Terminal: 6.0" long 14AWG Anderson connector
- Measures peak Amps, peak Watts ,voltage minimum (sag), peak temperature.
- Measures temperature in both Celsius & Fahrenheit
- Optional temperature sensor probe (excluded)
- Auxiliary battery to power watt meter for measurement down to 0V
- Optional Auxiliary battery probe (excluded)
- Accurate & precise – 0.01 A current and 0.01V voltage resolutions
- Rugged – handles 30A Charging rate (limited by 14AWG wire)
- Small & light with a tough plastic case
- Precision Alu-Chrom current sensing resistor, with only 0.001 Ohms resistance
- Factory calibration stores constants in EEPROM to compensate for component tolerances
Specification
Note:
- This item will not come with a temperature sensor probe
- Use for monitor battery pack while charging only
|
Product Reviews
|
|
|